AVer EXR6004-Mini user manual - Manual (Page 41)

35
 Using the following IP address: Assigns an IP address for the DVR system. Fill in the IP related
parameters in IP information section.
-
IP: Assign a constant IP address which a real IP address gives from ISP to DVR system.
- Mask: It is a bitmask used to identify the sub network and how many bits provide room for host
addresses. Enter the subnet mask of the IP address which user has assigned to DVR system.
- Gateway: A network device acts as a passageway to internet. Enter the network gateway IP
address
i
User only can setup one gateway for the DVR system. We do recommend setting the gateway data in port
LAN 1.
- DNS: Domain Name Server translates domain names (such as www.abb.com.tw) to IP addresses.
Enter the IP address of DNS if it is available.
- MAC Address: An identifier hardware address of DVR unit that is assigned by the manufacturer
for identification. User don
’t need to fill in, it will generated by system automatically.
 Obtain an IP automatically (DHCP): Assign the IP address by local DHCP server to DVR system.
 PPPOE: Point-to-Point Protocol over Ethernet is a network protocol for encapsulating PPP frames in
Ethernet frames. It is used mainly with ADSL services. If your network is using ADSL service
connecting to internet, and then, select PPPOE mode. Enter User ID and Password that is given by
your ISP for PPPOE connecting authority.
 DDNS: DDNS(Dynamic Domain Name Service) is a data query service mainly used on the Internet
for translating domain names into Internet addresses. Users can register their own domain name on
http://ddns.avers.com.tw . (See Appendix A )
- Domain Name
Enter the domain name that user has registered.
- Password
A password use to access DDNS that user has setup when register the domain name
- DDNS Server Name
Select your DDNS server. The default only has one DDNS server now. It may provide more DDNS
in future.
- DDNS Server Port
Fill in the port that connects to DDNS server. Default is 1053.
(4) Remote Upgrade Configuration
A port is using for the remote firmware upgrade through network.
(5) PCViewer Configuration
Activate Enable Anonymous Login to remotely access the DVR server without the need of password.
Fill in the PCViewer PORT for remote accessing connection.
(6) Network Time Synchronization
Adjust the DVR system time same as network time server. Fill in the Time Server IP address or domain
name and select the Time Zone. User can enable Automatic Synchronize at to set automatic
synchronize time on a daily basis. Or, user can click Synchronize Time Right Now to adjust time right
away.