AVer EXR6004-Mini user manual - Manual (Page 54)

48
- Video Loss: click the camera number (01 to 04) to set the alarm condition when video is lost.
Click the Detail button to setup the system to send out the alarm when video is lost and status last
the time that user has entered in Continuous trigger duration.
6. In (5) Sensor, select and click on the sensor number to set the condition for the system to alarm. If the
sensor normal status is high, set the sensor condition to low.
- IP Camera Sensor: To adjust sensor high/low that is connected on the IP camera.
- Enable/disable the Abnormal Event check box, to set the condition of the event for system to
alarm.
 Reboot: when the DVR system reboot without abnormal condition, the system will send out
the alarm message.

Abnormal Reboot: when the DVR system reboot in irregular condition, the system will send
out the alarm message.
 Recording is switched off: when the recording has been stopped, the system will send out
the alarm message.
 Network is switched off: when the network connection of DVR system is lost, the system
will send out the alarm message.

Hard Disk failed: when the hard disk doesn
’t work normally, the system will send out the
alarm message.
- Continue trigger duration: Set a time period that when sensor has been trigger and stay in the
same status for that period, then the alarm will be sent out.
7. In (6) Alarm Reset, click the camera number to set the reset condition of alarm. Once alarm is reset,
all alarm action will stop at the moment. If the sensor normal status is high, set the alarm reset
condition to low.
- IP Camera Sensor: To adjust sensor high/low that is connected on the IP camera.
- Alarm Reset Time: Set a time for the alarm auto reset. When an alarm happen such as motion
detected and video loss, the alarm will reset at the alarm reset time.
8. In (7) Action, you may now set the alarm action for the system to perform when the alarm condition is
activated.
- Launch E-Map: Display mini E-map screen.