Dynojet 250i: Pit Installation Guide - Manual (Page 11)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
1-1
C
H A P T E R
1
S
PECIFICATIONS AND
O
PERATING
R
EQUIREMENTS
Thank you for purchasing Dynojet’s In Ground Model 200iP/250iP Motorcycle
Dynamometer. Dynojet’s software and dynamometers will give you the power to get
the maximum performance out of vehicles you evaluate. Whether you are new to the
benefits of a chassis dynamometer or an experienced performance leader, the
repeatability and diagnostic tools of WinPEP 7 software and a Dynojet dynamometer
will give you the professional results you are looking for.
This document provides instructions for installing the in ground motorcycle
dynamometer (dyno). This document will walk you through operating requirements,
installation, accessories, and basic dyno operation. To ensure safety and accuracy in
the procedures, perform the procedures as they are described.
Document Part Number: 98229103
Version 4
Last Updated: 03-16-11
This chapter is divided into the following categories:
• Introduction, page 1-2
• Dynamometer Specifications and Requirements, page 1-5
• Dyno Electronics, page 1-10
• Verify the Pit Dimensions, page 1-11