Dynojet 250i: Pit Installation Guide - Manual (Page 72)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Pit Covers
2-50
I NSTALLING THE P IT C OVERS
1 Place the eddy current brake cover over the brake module.
2 Loosely secure the eddy current brake cover using four 3/8-16 x 1/2-inch button-
head flange screws. Do not tighten.
Figure 2-44: Install the Eddy Current Brake Cover
Note: If this is a European dyno, you will need to install the EEC finger guards.
Refer to Appendix C for EEC finger guard installation instructions.
PD174