Accessing the cpi – Dynojet 250i: Pit Installation Guide User Manual
Page 53
Advertising
I N S T A L L A T I O N
Routing Cables
Version 4
In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
2-31
A
CCESSING
THE
CPI
The CPI comes wired and ready to install. Should you need to re-route the cables so
they come out a different side of the box, use the following instructions to access the
CPI box.
1
Turn off the power to the dyno. Refer to “Main Dyno Power” on page 3-2 for more
information.
2
Remove the eight button-head screws securing the cover and set aside.
3
Remove the cover and set aside.
4
Open the front panel to access the breakers and Breakout board.
Figure 2-25: Accessing the CPI
PD027
cover
front panel access
Advertising
This manual is related to the following products: