Dynojet 250i: Pit Installation Guide - Manual (Page 42)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Carriage Plate and Tire Carriage
2-20
I NSTALLING THE T IRE C ARRIAGE
1 Starting from the back of the dyno, slide the carriage under the carriage clamps.
2 Slide the carriage screw and the bearing bracket toward the nut block until the
carriage screw is touching the nut block.
3 Secure the bearing bracket to the carriage using four 1/4-20 x 5/8-inch pan-head
torx bolts removed earlier.
Figure 2-16: Install the Tire Carriage
PD157
nut block
carriage clamp
carriage screw
bearing bracket
carriage