Dynojet 250i: Pit Installation Guide - Manual (Page 63)

I N S T A L L A T I O N
Routing Cables
Version 4 In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
2-41
R OUTING THE A IR P UMP P OWER , A IR F UEL S ENSOR , AND D YNO E LECTRONICS
P OWER C ABLES
1 Route the air pump power cable (P/N 76950318) from the CPI to the air pump.
2 Route the air fuel sensor cable (P/N 76950701) from the dyno electronics to the
air pump.
3 Route the dyno electronics power cable to your power source. Refer to “Dyno
Electronics” on page 1-10 for the dyno electronics power cable location.
Figure 2-36: Route the Air Pump Power, Air Fuel Sensor, and Dyno Electronics Power Cables
PD171
air pump assembly
CPI
dyno electronics
power cable
dyno
electronics
air pump
power cable
air fuel
sensor cable