Dynojet 250i: Pit Installation Guide - Manual (Page 50)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-28
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ROUTING CABLES
The CPI and dyno electronics must be placed near the conduits in the pit. Be sure to
keep the power and communications cables in different pit conduits. For the
following instructions, we will designate the pit conduits as shown in Figure 2-23.
Figure 2-23: Pit Dyno Room Layout
PD164
dyno
electronics
control panel
interface
(CPI)
control panel
junction box
monitor support and tray
route communications
cables in designated
conduit
route power cables
in designated conduit
cable track