Dynojet 250i: Pit Installation Guide - Manual (Page 32)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Eddy Current Brake
2-10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EDDY CURRENT BRAKE
This section will walk you through removing the eddy current brake (or retarder)
from the crate and attaching the brake to your dyno. To route and wire the
temperature sensor cable and the theta controller to the Breakout board refer to
“Routing the Eddy Current Brake, Battery, and Dyno Power Cables” on page 2-38 and
“Wiring the Breakout Board” on page 2-42.
You will need to provide equipment capable of lifting the eddy current brake off the
crate and into position in your dyno room. You will also need a pair of straps. Dynojet
recommends using continuous nylon loop style straps.
To prevent possible injury, unplug all power cords and disconnect the battery.
You will need the following parts:
• 62919004 Eddy Current Brake
• 37620622 Woodruff Key, 3/8 x 1-3/8" (2)
• 62240070 Driveline Assembly