Dynojet 250i: Pit Installation Guide - Manual (Page 70)

In Ground Model 200iP/250iP Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Pit Covers
2-48
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PIT COVERS
Before installing the covers, be sure to install the battery, pickup card, eddy current
brake, air brake, EEC Kit, and any accessories you may have purchased with your
dyno.
This section describes how to install the pit covers and drum guards.
You will need the following parts:
• 21226104 Right Pit Cover
• 21226105 Left Pit Cover
• 21226106 Eddy Current Brake Pit Cover
• 21229111 Drum Guard, Side (2)
• 21624103 Drum Guard Mounting Bracket
• 36561045 Screw, 1/4-20 x 5/8", Pan-Head, Torx (12)
• 36580434 Bolt, 3/8-16 x 1/2", Button-Head, Flange, Allen (12)
• DM150-020-005 Nut, crush, 1/4-20 (4)
C HANGING THE E DDY C URRENT B RAKE C OVER FOR R IGHT S IDE I NSTALLATIONS
This installation has been designed for the eddy current brake to be installed on the
left side of the dyno. Contact Dynojet for information regarding installation on the
right.
If you ordered an eddy current brake (retarder) and plan to mount it on the right
side, you will need to change the eddy current brake cover.
Figure 2-41: Eddy Current Brake Cover for Left and Right Side Installations
left side installation
looking from the bottom
right side installation
looking from the bottom