Losi LOSA0887 Manual - Manual (Page 10)

20
9
31
32
29
14
34
35
36
33
7
37
BAG B
7
Figure 15
Figure 16
Step 3. Insert two 4-40 x 7/8" cap-head screws (33) — one on each
side — through the second hole out in the top of the front shock
tower (34). Secure the screws (33) to the shock tower (34) by thread-
ing a 4-40 nut (35) over each screw (33) and tightening.
Tip: Use the included Team Losi wheel wrench/nut-driver.
Step 4. Press a 4-40 mini locknut (7) into the hex area in the top, rear of
each side of the front shock tower (34). Insert a 4-40 x 1/2" flat-head
screw (36) into each of the two front body mounts (37) from the side
with the recess for the head of the screw (36)
Step 5. Attach a front body mount (37) to the front of each side of the
front shock tower (34) so that the posts point up as shown in Figure
16. Secure the body mounts (37) by threading the screws (36) through
the tower (34) and into the locknuts (7).
Figure 15
Figure 16
Step 1. Position the front bulkhead (32) between the front kickplate
(14) and the chassis brace (29), as shown in Figure 15. Place a ball
stud washer (9) over the two 4-40 x 1/2" cap-head screws (31). Secure
the front bulkhead (32) to the front kickplate (14) by threading the
screws (31) through the holes in the top of the chassis brace (29)
through the front bulkhead (32) and into the front kickplate (14).
Step 2. Secure the front kickplate (14) to the front bulkhead (32) by
threading a 4-40 x 3/8" flat-head screw (20) through the center hole in
the front of the kickplate (14) and into the bulkhead (32).
20 31 9
36 35 33