Losi LOSA0887 Manual - Manual (Page 37)

ENGINE INSTALLATION
(Continued)
3 4
Step 12. Place a ball stud washer (9) over the four 4-40 x 1/2" cap-head
screws (31). Insert a 4-40 x 1/2" cap-head screw (31) through the four
holes in the engine as illustrated.
Step 13. Attach the engine to the engine mounts (164) by threading
the four screws (31) into the four holes shown.
*NOTE: The two engine mounts should be positioned with the
narrow end up as shown in Figure 78.
Tip: It's a good idea to use a thread-lock compound on the threads
of the screws in the engine mounts.
IMPORTANT NOTE: Make sure that the engine mounts
are installed correctly as indicated in Figure 78. The larger, partially
threaded holes should be positioned toward the front of the motor,
and the four screws should be installed into the smaller, fully threaded
holes.
Figure 77/78
9
Figure 77/78
162
162
9
164
Note: Pull Start engine shown. Rear exhaust
engine mounts the same.