Losi LOSA0887 Manual - Manual (Page 51)

197
201
190
195
187
RADIO INSTALLATION
(Continued)
4 8
Step 33. Attach the throttle linkage to the throttle servo horn by
inserting a 2-56 x 1/2" button-head screw (187) through the over-ride
slider (195) and into the middle hole in the longer arm of the throttle
servo horn (190) from the bottom. Once the screw (187) is snug up
against the over-ride slider (195), unscrew it one full turn to allow
some movement between the arm (190) and the slider (195). Secure
the screw (187) with a 2-56 locking nut (201).
Step 34. Insert the brake linkage Z-bend (197) from the top, through
the middle hole in the shorter arm of the throttle servo horn (190).
Figure 109
Figure 107
Figure 109
Figure 108
Step 31. Determine which throttle servo spline insert (200) will fit
your throttle servo by referring to the table on page 3, Figure 7C.
Step 32. Press the correct throttle servo spline insert (200) into the
hexagonal hole in the bottom of the throttle servo horn (190).
Figure 107
Step 30. For slide valve carburetors, you will need to remove the
shorter, perpendicular arm of the throttle servo horn (190), as shown
in Figure 107. Cut off the arm with heavy duty clippers or a Dremel
TM
hobby tool.
Slide Valve Carburetors
Figure 108
187 201
190
200
190