Losi LOSA0887 Manual - Manual (Page 47)

RADIO INSTALLATION
(Continued)
4 4
197
192
195
193
196
192
193
Figure 99
Figure 99
191
193
192
194
195
196
193
192
Figure 98
Figure 98
Rotary Valve Carburetors
If your engine comes equipped with a rotary valve carburetor, complete the steps in Figure 98 through Figure 104. If
your engine comes equipped with a slide valve carburetor, skip ahead to page 47 and complete the steps in Figure 105
through Figure 111.
Step 24. Slide a linkage collar (192) over the end of the throttle Z-bend
wire(191) (the shorter of the two), and position it approximately 1/4"
(6mm) from the Z-bend. Secure the collar (192) with a 4-40 x 1/8" set
screw (193).
Step 25. Place the throttle over-ride spring (194) (longer of the two
springs) over the wire (191) and against the collar (192). Slide a plastic
over-ride slider (195) onto the wire (191), so that the long end is
towards the Z-bend.
Step 26. Place a brake over-ride spring (196) (black, shorter of the two
springs) over the wire (191) and against the over-ride slider (195).
Place a linkage collar (192) over the end of the wire (191), so that the
springs are somewhat compressed, and secure it with a 4-40 x 1/8"
setscrew (193). The collar (192) should be positioned at the end of the
wire (191). Final adjustments will be made later.
Step 27. Slide a linkage collar (192) over the end of the long, brake Z-
bend wire (197), and position it aproximately 2 1/4" (60mm) from the Z-
bend. Secure the collar (192) in place with a 4-40 x 1/8" set screw
(193).
Step 28. Slide a plastic over-ride slider (195) onto the wire (191), so
that the long end is towards the Z-bend. Place a brake override spring
(196) (black, shorter of the two springs) over the wire (191) and against
the slider (195).
Step 29. Slide a linkage collar (192) over the end of the wire (191) until
it just touches the spring (196). Secure it with a 4-40 x 1/8" setscrew
(193). Once again, final adjustments will be made later.
193
193