Losi LOSA0887 Manual - Manual (Page 23)

102
96
101
95
95
101
96
103
77
Figure 46
Figure 47
Step 61. Place a 1/4" x .020 washer (96) over each of the two 4-40 x 5/
8" set screws (27).
Step 62. While holding the brake lever clips (101) in position on the
brake lever (102), slide brake lever clips (101) over the 4-40 x 5/8" set
screws (27). Be sure the top brake lever clip (101) points tward the
rear of the gearbox and the lower brake lever clip (101) points toward
the front.
Step 63. Secure the brake lever clips (101) with two 4-40 steel locknuts
(95). Tighten the nuts (95) until they are just snug, then back them off
about 1/4 turn, so the brake lever clips (101) can still be moved slightly.
Step 64. Insert a 3/16" E-clip (103) into the groove in the end of the
brake shaft (77) to retain the brake hub (98).
BAG C (Continued)
Step 59. Slide a brake lever clip (101) over the brake lever (102) flange
side first. Slide the clip (101) all the way up the brake lever (102) to the
sharp bend.
Step 60. Slide the other brake lever clip (101) over the end of the brake
lever (102) with the flange side facing away from the first brake lever
clip (101).
IMPORTANT NOTE: Ensure brake lever clips are oriented
in opposing directions with the flanged sides facing apart as shown.
Figure 46
Figure 47
96 95 103
2 0
101
101
102