Losi LOSA0887 Manual - Manual (Page 52)

RADIO INSTALLATION
(Continued)
4 9
Figure 111
Figure 111
Step 35. Snap the 4mm ball cup (204) onto the ball on the carburetor.
Make sure the ball is pointing toward the right side of the truck and
slightly upward.
Step 36. Press the throttle servo horn (190) and throttle servo spline
insert (200) onto the output shaft of the servo, and secure it with the
screw included with your servo. Be sure the servo output shaft is
centered and the servo horn is aligned properly, as shown.
Step 37. Insert the end of the brake lever (102) through the hole in the
over-ride slider (195) on the brake likage.
Step 38. Place a linkage collar (192) over the end of the brake lever
(102) and secure it with w 4-40 x 1/8" set screw (193).
*NOTE: The slider should fit loosely under the linkage collar
to prevent binding.
Figure 110
Figure 110
Slide Valve Carburetors
Step 39. Attach one end of the throttle return spring (202) to the hole
in the eyelet (199). Attach the other end of the spring (190) to the hole
toward the edge of the servo arm as shown.
Step 40. Remove the air filter (165) from the air filter boot (166). Check
to see that the throttle return spring is holding the carburetor closed,
and that the linkage is not pulling the carburetor open.
Step 41. Looking through the air filter boot (166) into the carburetor,
check the opening of the small, half-moon area near the side. This
opening should be approximately 1/32" (1mm) in the fully closed po-
sition. If it is not, refer to your engine instructions and adjust the idle
adjustment screw until the opening is 1/32" (1mm) with the throttle
closed.
193
192
193
195
102
190
204
202
190
199