Losi LOSA0887 Manual - Manual (Page 29)

2 6
BAG D (Continued)
Step 23. Slide the battery box (125) into place on the back of the
chassis (19). The top flange of the battery box (125) should fit be-
tween the shock tower (123) and the gearbox. The back of the chassis
(19) should fit snugly into the recess in the bottom of the battery box
(125). Be sure that all the holes line up.
Step 24. Place a gold ball stud washer (9) over each of the 4-40 x 1/2"
cap-head screws (31). Secure the rear shock tower (123) and battery
box (125) to the gearbox by threading the 4-40 x 1/2" screws (31), with
washers (9) attached, throught the tower (123) and battery box (125)
and into the gearbox.
Step 25. Secure the bottom of the battery box (125) to the chassis (19)
with two 4-40 x 3/8" flat head screws (20).
Figure 61
Figure 60
Figure 61
Figure 60
Step 21. Attach one end of the rear camber link assembly from Step 19
to the ball stud (38) in the right rear hub (112) and the other end to the
ball stud (38) in the rear shock tower (123).
Tip: Remember to attach the turnbuckles so that the threads are in
the same direction on all your linkages.
Step 22. Repeat Step 20 for the left side of the truck.
*NOTE: It's a good idea to leave your truck sitting on a flat
surface until the shocks are assembled and installed. This will keep
the dogbones in place.
9 20 31
123
38
112
123
31
9
125
19
20