Losi LOSA0887 Manual - Manual (Page 8)

11
22
28
29
28
23
17
30
29
BAG A (Continued)
Figure 11
Step 22. Attach one end of the rod to the ball stud (11) in the servo
arm (22) and the other to the ball stud (11) in the servo saver top (3) as
shown in Figure 11.
Figure 12
Figure 13
Step 23. Press a rubber tank-mounting grommet (28) into each of the
three large holes in the top of the chassis brace (29) as shown. The
grommets (28) should be centered, top-to-bottom, in the holes of the
chassis brace.
Step 24. Line up the three posts on the fuel tank (30) with the three
holes with grommets in the chassis brace (29). Install the fuel tank
(30) on the chassis brace (29) from the bottom by pressing the three
posts on the tank (30) through the three rubber grommets (28).
Step 25. Place a #4 washer (23) over each of the three 4-40 x 3/8" cap-
head screws (17). Thread a screw (14) through each of the grommets
(28) and into the posts in the fuel tank (28). Hold the tank (30) all the
way up against the chassis brace (29). Tighten each of the three
screws (14) until the washer (23) just touches the grommet (28).
*NOTE: The screws should not be tightened so that grommet
smashes. By tightening the screws until the washers just touch the
grommets, the tank will be "shock mounted". This helps the fuel
from foaming while running the truck.
5
Figure 11
Figure 12
Figure 13
28
17 23