Losi LOSA0887 Manual - Manual (Page 30)

BAG E
2 7
Figure 62
Step 1. Place one shock O-ring (126) into the cartridge body (127),
making sure that the O-ring (126) sits flat on the bottom of the car-
tridge body (127).
Step 2. Insert the cartridge spacer (128) into the cartridge body (127)
followed by a second O-ring (126).
Step 3. Once the second O-ring (126) is inserted, and is flush with the
top of the cartridge body (127), “snap” the cartridge cap (129) onto
the cartridge body (127).
Step 4. Make four cartridge assemblies.
*NOTE: Cartridges in some kits may be pre-assembled at the
factory.
Figure 63
Step 5. Place a drop of shock fluid (132) on the grooved end of each
shock shaft [front (130), rear (131)] and slide a cartridge, hex end first,
down the shock shaft (130), (131) toward the threads.
Figure 62
Figure 63
126 128
130 131
126
128
129
127
130 131