Losi LOSA0887 Manual - Manual (Page 26)

112
114
117
109 38
56
115
114
116
BAG D (Continued)
2 3
Figure 55
Figure 54
Figure 55
Figure 54
Step 5. Thread a 3/8" ball stud (38) into the outer hole in the right rear
hub (112) from the side opposite the letter ('L' and 'R') designating left
and right. Place a "foam thing" (56) over the ball stud (38).
Step 6. Press a 3/16" x 3/8" bearing (114) into the inside of the rear hub
(112). Slide the rear axle (109), from the inside, through the bearing
(114).
Step 7. Slide the center bearing spacer (115) over the axle and against
the bearing (114). Slide the second bearing (114) over the axle and
press it into the outside of the rear hub (112).
Step 8. Place a rear axle spacer (116) over the rear axle, against the
outside bearing (114). The small side of the spacer (116) should be
positioned against the outside bearing (114).
Step 9. Secure the rear axle (109) and spacer (116) by pressing a 1/16"
x 7/16" pin (117) through the small hole in the rear axle (109). The pin
(117) should be centered in the rear axle (109).
38
114 117 115 116
31 51 46
Step 10. Slide a suspension ball (121) over a 4-40 x 1/2" cap head
screw (31) and thread it into the middle shock mount hole on the right
rear suspension arm (118) from the back side.
Step 11. Slide an outer rear hinge pin (51) partially through the out-
side of the right rear suspension arm (118) from the rear. Slide a plastic
rear hub spacer (120) over the pin (51) and against the rear portion of
the suspension arm (118).
Step 12. Place the right rear hub (112), marked 'R', (ball stud facing
rearward) between the outer rails of the suspension arm (118), against
the spacer (120). Slide the hinge pin (51) partially through the hub
(112).
Step 13. Insert another rear hub spacer (120) (not shown in Figure 55)
between the rear hub (112) and the forward rail of the suspension arm
(118). Slide the hinge pin (51) through both sides of the suspension
arm (118), the rear hub (112), and both spacers (120). Secure the hinge
pin with two 1/8" E-clips (46).
Step 14. Repeat Steps 1-13 for the left suspension arm (119) and left
hub (113).
46
51
31
121
118
120
112