Lights and windshield wipers, Exterior lighting – Mercedes-Benz M-Class 2012 Owners Manual User Manual

Page 114

Advertising
background image

The hazard warning lamps are deactivated

automatically if the vehicle returns to a speed

of over 6 mph(10 km/h) after a full

application of the brakes.

i

The hazard warning lamps still operate if

the ignition is switched off.

Adaptive Highbeam Assist

You can use this function to set the

headlamps to change between low beam and

high beam automatically. The system

recognizes vehicles with their lights on, either

approaching from the opposite direction or

traveling in front of your vehicle, and

consequently switches the headlamps from

high beam to low beam.
The system automatically adapts the low-

beam headlamp range depending on the

distance to the other vehicle. Once the

system no longer detects any other vehicles,

it reactivates the high-beam headlamps.
The system's optical sensor is located behind

the windshield near the overhead control

panel.

X

To activate: activate the Adaptive

Highbeam Assist function using the on-

board computer (

Y

page 234).

X

Turn the light switch to c or Ã.

X

Press the combination switch beyond the

pressure point in the direction of arrow :

(

Y

page 111).

If it is dark and the light sensor activates

the low-beam headlamps, the _

indicator lamp in the instrument cluster

lights up.
If you drive faster than approximately

28 mph (45 km/h):
the headlamp range is set automatically

depending on the distance between the

vehicle and other road users.
If you drive faster than approximately

35 mph (55 km/h) and no other road users

are identified:
the high-beam headlamps are switched on

automatically. The K indicator lamp in

the instrument cluster also lights up.
When you drive slower than approximately

30 mph (45 km/h) or if other road users

are identified or if the roads are sufficiently

illuminated:
the high-beam headlamps are switched off

automatically. The K indicator lamp in

the instrument cluster goes out. The _

indicator lamp in the instrument cluster

stays on.

X

To deactivate: move the combination

switch back to its normal position.

The _ indicator lamp in the instrument

cluster goes out.

G

WARNING

The Adaptive Highbeam Assist is only an aid

intended to support you while driving. The

driver is and remains responsible for proper

vehicle lighting in accordance with the

prevailing light, sight and traffic conditions.
The system may be impaired or unavailable

when

R

visibility is poor, e.g. due to snow, rain, fog,

or heavy spray

R

the optical sensor area of the windshield is

dirty, fogged up, or covered by a sticker for

example

112

Exterior lighting

Lights

and

windshield

wipers

Advertising