Breakdown assistance, Flat tire – Mercedes-Benz M-Class 2012 Owners Manual User Manual

Page 334

Advertising
background image

Do not switch off the tire inflation

compressor during this phase.

X

Allow the tire inflation compressor to run

for five minutes. The tire should then have

attained a pressure of at least 180 kPa

(1.8 bar/26 psi).

!

Do not operate the tire inflation

compressor for longer than eight minutes

at a time without a break. It may otherwise

overheat.
The tire inflation compressor can be

operated again once it has cooled down.

If a pressure of 180 kPa (1.8 bar/26 psi) has

been achieved after five minutes, see

(

Y

page 332).

If a pressure of 180 kPa (1.8 bar/26 psi) has

not been achieved after five minutes, see

(

Y

page 332).

Tire pressure of at least 180 kPa

(1.8 bar/26 psi) is not reached

If, after five minutes, a pressure of 180 kPa

(1.8 bar/26 psi) has not been achieved:

X

Switch off the tire inflation compressor.

X

Unscrew the filler hose from the valve of

the faulty tire.

X

Very slowly drive forwards or reverse

approximately 30 ft (10 m).

X

Pump up the tire again.

G

WARNING

If after five minutes a pressure of 180 kPa

(1.8 bar/26 psi) cannot be achieved, the tire

is too badly damaged to be repaired reliably

using TIREFIT.
In this case TIREFIT cannot seal the tire

properly.
Do not drive any further.
Contact the nearest authorized Mercedes-

Benz Center for assistance or call Roadside

Assistance.

Tire pressure of 180 kPa (1.8 bar/

26 psi) is reached

X

Switch off the tire inflation compressor.

X

Unscrew the filler hose from the valve of

the faulty tire.

!

After use, excess TIREFIT may run out of

the filler hose. This could cause stains.
Therefore, place the filler hose in the plastic

bag which contained the TIREFIT kit.

X

Stow the tire sealant bottle and the tire

inflation compressor.

X

Pull away immediately.

G

WARNING

Do not exceed a vehicle speed of 50 mph

(80 km/h). A TIREFIT repair is not designed to

operate at higher speeds.
The sticker must be attached on the

instrument cluster where it will be easily seen

by the driver.
Vehicle handling characteristics of a TIREFIT

repaired tire may change. Adapt your driving

accordingly.

X

Stop after driving for approximately ten

minutes and check the tire pressure with

the tire inflation compressor.

G

WARNING

If tire inflation pressure has fallen below

130 kPa (1.3 bar/26 psi) do not continue to

drive the vehicle.
Park your vehicle safely away from the

roadway and contact the nearest authorized

Mercedes-Benz Center or Roadside

Assistance.
Have the damaged tire replaced.

X

Correct the tire pressure if it is at least

130 kPa (1.3 bar/20 psi) (for the required

values, see the Tire and Loading

Information placard on the driver's side

B-pillar or the tire pressure table inside the

fuel filler flap).

332

Flat tire

Breakdown

assistance

Advertising