Opening/c losing, Sliding sunroof – Mercedes-Benz M-Class 2012 Owners Manual User Manual
Page 91
Operating the sliding sunroof
Opening and closing
i
You can continue to operate the sliding
sunroof after switching off the engine or
removing the SmartKey from the ignition
lock. This function is available for up to five
minutes or until the driver's or front-
passenger door is opened.
Overhead control panel
:
To raise
;
To open
=
To close/lower
X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Press or pull the 2 switch in the
corresponding direction.
i
If you press the 2 switch beyond the
point of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by operating the
switch again.
When opening and raising the roof,
automatic operation is only available if the
sliding sunroof is in the closed position.
The sun protection cover automatically opens
along with the sliding sunroof. You can open
or close the sun protection cover manually
when the sliding sunroof is raised or closed.
Resetting
Reset the sliding sunroof if it does not move
smoothly.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Raise the sliding sunroof fully at the rear
(
Y
page 89).
X
Keep the 2 switch pressed for another
second.
X
Make sure that the sliding sunroof can be
fully opened and closed again (
Y
page 89).
X
If this is not the case, repeat the steps
above again.
!
If the sliding sunroof still cannot be
opened or closed fully after resetting,
contact a qualified specialist workshop.
Operating the panorama roof with
power tilt/sliding panel
Opening and closing
Overhead control panel
:
To raise
;
To open
=
To close/lower
The panorama roof with power tilt/sliding
panel can only be operated when the roller
sunblind is open.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Push or pull the 2 switch in the
corresponding direction.
Sliding sunroof
89
Opening/c
losing
Z