SINGER 7258 STYLIST Instruction Manual - Manual (Page 76)

76
STRAIGHT STITCH FOOT
Use this foot when close control is needed according to the
type of fabric or stitching procedure.
OVERCASTING FOOT
This foot is used to guide fabric when overcasting. Place your
fabric under the foot with its edge against the edge guide and
start to sew.
DARNING & EMBROIDERY FOOT
This special foot may be used to create free motion
embroidery, free motion monograms, as well as free motion
quilting, also known as stippling.
Machine Preparation
• For free motion embroidery and monograms: Set machine
for Zigzag Stitch in the width you desire. The stitch length will
be controlled by the movement of your hands.
• For free motion quilting (stippling): Set machine to Straight
Stitch. The stitch length will be controlled by the movement
of your hands.
• Cover feed dogs with darning plate.
• Attach Darning & Embroidery Foot, making sure the
extension arm sits over the needle clamp screw.
Sewing Instructions
1. Stencil or draw your pattern onto the right side of your
fabric.
2. Insert fabric under presser foot.
3. Lower presser foot and begin moving your fabric following
your design lines.
5. SPECIAL ACCESSORIES
NOTE: For better control when free motion sewing, it
is recommended that you hoop the section of fabric
that you are working with. Hand movement will control
the quality and look of your stitch. Do not forget to
lower your presser foot.
Extension arm
Bras de rallonge
Brazo extensor
Edge guide
Guide de bordure
Guía de orillas