SINGER 4210 Inspiration User Manual

Page 17

Advertising
background image

Tirez le fil de la bobine. Maintenez-le fermement au-dessus du
premier guide-fil. Ensuite, tirez le fil vers le bas pour l'introduire
dans le guide-fil.

7

30

Enfilage de la machine

Remplissage de la canette

Tournez le volant vers vous jusqu'à ce que l'aiguille soit
dans la position la plus haute.

Relevez le de pied presseur.

Placez la bobine de fil sur le porte-bobine horizontal. Fixez
le fil dans la bonne position avec le grand ou le petit
capuchon de bobine, suivant la taille de votre bobine de fil.

Devanando la bobina

Gire el volante hacia usted hasta que la aguja esté en la posición
más alta.

Levante la palanca del prensatelas.

Deslice el hilo en el portacarrete horizontal. Asegure la hebra en
su sitio con el sujetador grande o pequeño, dependiendo del
tamaño del carrete de hilo.

Jale el hilo del carrete, sostengalo con firmeza sobre el primer guía hilos.
Posteriormente, jale el hilo hacia adentro del guía hilos.

Ensartando la Máquina

Winding the bobbin

Turn handwheel counter clockwise until the needle is in the
highest position.

Raise presser foot lifter.

Slide thread onto horizontal spool pin. Secure thread in place
with either the large or small spool pin holder, depending on the
size of your thread spool.

Pull the thread from the spool, hold firmly over the first thread
guide. Then push the thread down, snapping it into the thread guide.

Threading the machine

31

Faites passer le fil par un des trous de
la canette conformément à
l'illustration en laissant dépasser un
bout de fil de 10 cm.

31

7

Tirez le fil de la bobine et faites-le passer par le deuxième guide-fil.

Placez le fil à droite du disque de tension du dévidoir, puis faites-le passer à
gauche sous le disque et autour du disque, en tirant le fil vers le dévidoir de
canette.

Enfilage de la machine

Jale la hebra del carrete hacia el segunda guíá hilos.

Coloque el hilo a la derecha del tensor, dé vuelta a la izquierda como se muestra en
la imagen, jale el hilo hacia el devanador de bobina.

Pase el hilo por uno de los orificios de
adentro hacia afuera de la bobina
como se muestra, dejando una hebra de
4 centimetros aproximadamente.

Ensartando la Máquina

Pull thread out from the spool through the second thread guide.

Place the thread to the right of the Bobbin winder disc, then swing the bobbin thread
to the left going under and around the disc, pulling the thread toward the Bobbin
winder.

Pull the thread through the hole in the
bobbin as shown, leaving a 4” tail.

Threading the machine

Advertising
This manual is related to the following products: