Welch Allyn 206EL Propaq Encore Vital Signs Monitor - User Manual - Manual (Page 16)

12 Getting started Welch Allyn Propaq Encore Vital Signs Monitor
2. Press any button below the equipment alert screen to acknowledge the alert. The
monitor will display the Mode Setup window (shown on page 23).
3. Press these buttons to select one of the Factory patient modes for use:
After you press YES, the monitor will display the Time/Day window.
4. Press NEXT, UP, and DOWN as needed to set the time and date. Then press ENTER
to store the new time and date.
5. Turn off the monitor, then turn it on again so the settings will take effect.
The monitor is ready for use. If you want to store some customized patient mode program
settings, refer to page 23.
If you follow these steps and the equipment alert reappears at powerup, the monitor may
need to be serviced and the battery replaced. Contact a qualified service person.
Factory Adult mode POWERUP*, YES.
Factory Pediatric mode NEXT, POWERUP*, YES.
Factory Neonatal mode NEXT, NEXT, POWERUP*, YES.
Note These display screens are only displayed in this order if the PROGRAM FAULT
equipment alert occurs.