V.I.O. Stream - Manual (Page 19)

STREAM User Manual
19
MAC OS X Setup
1. Plug in the STREAM. Push the button on for less than 1 second and release. Wait
approximately 25 seconds. Your computer should indicate that New Hardware is
detected. It may ask for permission to upgrade your RNDIS driver, and if so,
confirm/select ‘Yes’ or ‘OK’ to allow this to happen. If not, it will direct you to set up
your network preferences. Select the Network Preferences button as shown below.
2. Change your settings to match the RNDIS configuration shown below. You may need to
put in your admin password to make this change. This can be done by clicking the lock in
the lower left corner, and using your password to unlock the lock. Once the change is
complete, select the apply button, then relock the lock if necessary.