V.I.O. Stream - Manual (Page 8)

STREAM User Manual
8
2. Replace the end cap onto the STREAM.
• Squeeze the two latches on the USB end cap.
• Insert the end cap into the back end of the STREAM as shown below and release the latches.
• Ensure that the latches are firmly seated into the latch holes to ensure IP67 protection
Set up the V.I.O. STREAM with a Battery end cap and mount
1. Remove the end cap from the STREAM and install the Micro SDHC card included with the STREAM.
• Squeeze the two latches on the STREAM end cap and remove the end cap.
• Insert the Micro SDHC card into the card slot (as shown below), until the card clicks into place. The
Micro SDHC card label will face upward when it is inserted correctly.