V.I.O. Stream - Manual (Page 43)

STREAM User Manual
43
LED’s
The picture below shows where to find the LED and Microphone hole.
Powering up
When the STREAM is in the off state and the button is pressed briefly (<1 Second), the LED will turn Orange then
Green. At this point the button may be released. The LED will be Orange for 15 seconds. At this point the USB
driver or Wi-Fi will begin initialization and the LED will then be solid green for approximately 10 seconds while
communication is established. The LED will begin to flash slow green (1x/second) when ready for operation. This
indicates a standby or streaming only state.
Standby or Streaming only
The slow (1x per second) green blinking LED indicates the Standby or Streaming state.
Recording
A slow (1x per second) red blinking LED indicates the STREAM is in Record Mode.
Low Memory
When the STREAM detects that available space on the Micro SDHC card is getting low while recording, it will
change the LED to Orange and will continue to slow blink.
Low Battery
When the STREAM detects that the battery is getting low, it will increase the blink speed to fast blink. The color of
the LED will stay the color of the current state (green for standby/streaming, red for recording/streaming.
Record video
The basics
1. When the STREAM boots up, it goes to Record Standby automatically. If you have set up the STREAM
to do automatic streaming on power up, it will also be streaming video.
2. Once you are in standby mode (blinking green LED), you can start recording using one of two methods.
Either you can use the Web Programmable HTTP/XML interface to send a command to the camera to
start recording, or you can briefly (< 1 second) press and release the button. Once the button press or