V.I.O. Stream - Manual (Page 7)

STREAM User Manual
7
Get Ready
The STREAM is shipped with everything you need to start making great videos in HD, but a bit of assembly is
required before you get started.
Set up the V.I.O. STREAM with a USB End Cap
1. Remove the end cap from the STREAM and install the Micro SDHC card included with the STREAM.
• Squeeze the two latches on the STREAM end cap and remove the end cap.
• Insert the Micro SDHC card into the card slot (as shown below), until the card clicks into place. The
Micro SDHC card label will face upward when it is inserted correctly.
• Note that the Micro SDHC card has a notch on the right hand side when the label is facing up. If
you insert the Micro SDHC card upside down, this feature will prevent the card from being fully
inserted. DO NOT use unnecessary force to put the card into the slot. If it will not go all the way
into the slot, remove the card and make certain the label is visible and the notch is to the right.
• To remove the Micro SDHC card when it is latched, push and release the back edge of the card
slightly and it will unlatch and project out a short distance. It can then be pulled out. There is a
ridge at the top of the back end of the card or a small notch on the outer edge of the right side of
the Micro SDHC card that may help you to remove the card after it is unlatched.
Note: The STREAM can use Micro SDHC cards from 4GB up to 32 GB maximum. Work with your sales
representative to determine the correct size for your integration needs.