V.I.O. Stream - Manual (Page 49)

STREAM User Manual
49
Prepare the STREAM
• If using the battery end cap, check the battery level when the STREAM goes into Standby mode. If
you do not have at least half the battery power remaining, power down the recorder and install
fresh batteries or charge the battery. It’s essential that the STREAM not lose power while the
firmware upgrade is in progress.
Install the firmware
IMPORTANT NOTE: If using the battery end cap, do not install the firmware unless you have verified
that the batteries have an adequate charge, see Prepare the STREAM, above.
• From a power down state, hold the power button on the STREAM for 5-6 seconds until the LED
turns orange. After a moment, the LED will begin to blink orange at 1x/second.
• IMPORTANT: Do not turn the STREAM off or remove the Micro SDHC card while the firmware is
being updated. The update process takes only a short time (1 – 2 minutes).
• When the update is complete, the LED will change to either a solid green or solid orange state.
Solid green indicates success. You will then need to power off the camera and power if back on
again. If you see a solid orange state, try doing the update again.
Check out the STREAM
• Power down then power up the STREAM.
• Using the integrators HTML page, look at the system settings to make sure that the firmware
version is correctly updated.