V.I.O. Stream User Manual
Page 48
STREAM User Manual
48
The Remote ID channel of the wireless remote is set using a small rotary dial located inside the remote
control.
• To adjust the channel you will need to open the remote control unit by removing the four small
Phillips screws at the four corners of the remote.
• Use a small flat bladed screwdriver to carefully rotate the pointer to the desired setting. Take care
to protect the inner workings of the remote from dust and moisture while the cover is removed
• Replace the cover, tightening the four screws uniformly to create even pressure against the seal
Update the firmware on the V.I.O. STREAM
From time to time there may be updates to the firmware in the STREAM available to camera owners. These
updates improve system performance and may add new features. If you are having an issue, please check the
support site below to determine if there has been a firmware update.
Download a firmware update
To check if there is a firmware update available, go to:
To download the new firmware, click on the Download Firmware Upgrade link toward the bottom of the
page. The firmware will be downloaded in a ZIP file which contains the firmware plus a version specific set of
the instructions given below.
Install the Firmware
Put the new firmware on a Micro SDHC card
• Unzip the downloaded firmware upgrade file
You will get a folder containing a PDF with upgrade instructions, and the firmware upgrade file
which will have the format: Stream-x.yy.bin where “x.yy” is the version number for this upgrade.
• You can put the firmware on a Micro SDHC card in one of two ways
1. Put the Micro SDHC card into an Micro SDHC card slot on your computer or into an Micro
SDHC card reader attached to your computer, OR
2. Connect you computer directly to the recorder with a Micro SDHC card in it using the USB
link and going to Mass Storage Device mode (<ip address>/api/system/msd).
• In either case, simply drag the firmware BIN file onto the Micro SDHC card in Windows Explorer or
OS X Finder. The firmware file goes into the top level folder/directory. The firmware does NOT go
into the DCIM folder/directory.
If there is an upgrade file for an older version of the firmware on this Micro SDHC card delete that
file at this time.
Put the Micro SDHC card with the firmware into the recorder
• If you used a Micro SDHC card slot or a Micro SDHC card reader attached to your computer,
dismount and remove the Micro SDHC card and put that card into the STREAM and replace your
end cap.
• If you copied the upgrade file directly onto the Micro SDHC card in the recorder using the USB
link, disconnect the link to power down the recorder, and reconnect.