BendixKing AV8OR - Manual (Page 188)

Honeywell Bendix/King AV8OR Handheld User’s Guide
System Setup Function D200803000008
Page 2-148 Rev 5 Mar 2012
© Honeywell International Inc. Do not copy without express permission of Honeywell
•
Req Runway Surface : The options are Any and Hard Only .
The Required Runway Surface type is also used when using
the DIRECT TO soft key to search for the nearest airports in
VFR Moving Map mode. When runway surface is set to ANY,
airports with either hard or soft runways are displayed. When
surface is set to HARD ONLY, only airports with hard surface
runways are displayed and soft-runway airports are ignored.
•
MIN R/W LENGTH: This field contains the minimum length of
the main runway at those airports that are included when the
ten nearest airports are shown. Select the length field and use
set the minimum length value. The available values are
specified in steps of 100 feet from 0 to 16,000 feet or in steps
of 50 meters from 0 to 4900 meters when the runway length
units are set to meters. By setting a minimum length, airports
with shorter runway lengths are not included in the search for
the closest airport. To disable this filter set the minimum
runway length to 00000 feet.
MAP SETUP
The initial Map Systems Setup Options page allows different
mapping options to be configured. Refer to Figure 2-197.
Figure 2-197: System Setup – Map System Setup Options
There are five groups of features for each of the map layers. They
are: Common Features, Point Features, Line Features, Airspace and
Overlay. Each shows in a tab across the top.
Tap the SAVE & EXIT soft key to save any changes and go back to
the previous menu.
Tap the EDIT soft key to edit the data for the tabbed screen on top.