Check config, Weather radar annunciations, Wx flt – BendixKing SG 465 System EFS 50 User Manual

Page 159: Wx off, Busy vp, Stb lmt, 429 flt, Ant flt, Tx flt, Range

Advertising
background image

Fault Annunciations

6.4

Issued 4/95

SW 06/07/08/11

will be placed in the data field.
Refer to Figure 6.3.

CHECK CONFIG

A yellow “CHECK CONFIG”
message will display in the upper
right corner of the EHSI and
EADI whenever the system con-
figuration memory in the symbol
generator and aircraft installation
rack do not match.

Test routines resident in the sym-
bol generator select the best pos-
sible system configuration to use,
however, the selected configura-
tion may not be the intended one.
Once the CHECK CONFIG mes-
sage is noted, extreme caution
should be exercised when using
any information. It is also most
important that the aircraft be
taken to an authorized dealer for
repair as soon possible.

WEATHER RADAR
ANNUNCIATIONS

When a weather radar failure
occurs while operating in the WX
mode, a white alphanumeric
annunciation appears below the
Weather Mode annunciation.

The annunciations capable of
being displayed when interfaced
with an RDS 81, 82/VP, 84/VP
and 86/VP are listed below in
order of priority.

WX FLT

Advises a mismatch of mode, tilt,
gain or range information

between the EFIS and radar RT
has existed for more than 30 sec-
onds.

WX OFF

This annunciation (“OFF” before
SW 08) is displayed when the
radar is off.

BUSY VP

Displayed when the radar is in
the continuous VP mode.

STB LMT

Displayed when the combination
of tilt, roll, roll trim and pitch
exceeds +/- 30 degrees.

429 FLT

Displayed when 429 control data
is missing or incorrect at the
radar RT.

ANT FLT

Displayed when the measured
antenna tilt does not match the
requested tilt angle.

TX FLT

Displayed when a fault is detect-
ed in the radar transmitter.

RANGE

Displayed when the pilot has
selected the 1000 mile range on
the EFIS. The radar is unable to
operate at this range and is
placed in standby.

Advertising