Gain, Pull arl, Tilt – BendixKing SG 465 System EFS 50 User Manual

Page 54

Advertising
background image

Radar Operation

2.3.7

Issued 4/95

SW 06/07/08/11

GAIN

Manual gain control becomes
active when GND MAP is select-
ed. In all other modes, gain is
internally set.

PULL ARL

Only present when an RDS 86 or
RDS 86VP is installed. Automat-
ic Range Limit displays a blue
area behind weather systems
where weather detection is no
longer possible because of atten-
uation.

TILT

Permits manual adjustment of
antenna tilt 15 degrees up or
down to enable the pilot to ana-
lyze the weather presentation.
The tilt angle is displayed below
the NAV source annunciator on
the radar tilt annunciator line.

UP

TILT

DN

GAIN

PULL ARL

If a CP 466A is installed, pull the
Tilt selector knob, PULL STAB
OFF, for “STAB OFF” operations.
“STAB OFF” will appear on the
Radar Fault/Warning line dis-
played below the NAV source
annunciator just under the Anten-
na Tilt annunciation line.

If a CP 466B is installed, pull the
Tilt selector knob, PULL AUTO,
for Auto Tilt. If selected, an “A”
will follow the tilt direction indica-
tion arrow preceding the internal-
ly calculated Auto tilt angle sup-
plied by the ART.

Advertising