BendixKing SG 465 System EFS 50 - Manual (Page 58)

MFD Operation
2.4.3 Issued 4/95 SW 06/07/08/11
the pilot can complete the entire
checklist by using only the enter
button.
Normally, pressing the ‘ENT’ but-
ton will cause an unchecked
checklist line to be checked and
the cursor to advance to the next
unchecked line. At the end of a
page pressing the ‘ENT’ button
will cause the cursor to advance
to the next page (if available) and
to check the first unchecked line
on that page. If no unchecked
items exist between the cursor
position and the end of the list,
the cursor is placed on the first
unchecked page which refer-
enced the specific list.
NAV BUTTON
The NAV button may be config-
ured at the time of installation
and certification to operate in one
of two methods.
❏ Configuration option number
one will slave the MFD to the #1
EHSI. The NAV push button will
cause the MFD to display either
the same NAV sensor as dis-
played on the EHSI or the LNAV.
When this configuration is select-
ed the 1-2 push button allows
selection between the on side
and off side sensors. Once a
side is selected, that side will
remain the selected side until 1-2
button is pressed again. This
allows the pilot the ability to
select the off side sensor to pro-
vide himself a constant visual
cross comparison.
❏ Configuration option number
two enables the NAV button to
function identical to, but indepen-
dent of, the one on the CP 467.
When this configuration option is
selected the pilot can select any
available nav sensor for display
on the MFD independent of what
is displayed on the EHSI.
RANGE UP/DOWN BUTTONS
With checklist inactive, these but-
tons will function identical to, but
independent of, the range but-
tons on the CP 467. With check-
list active, these buttons will
move up and down the “checklist
tree” through the different levels
of index pages.
Refer to section 2.1 EHSI OPER-
ATION for detail information.
CHECKLIST
BUTTON
This button is not functional for
Software 06 or 07. The message
“FUNCTION NOT IMPLEMENT-
ED” will be displayed on the MFD
if this button is pressed with
these software versions.
With software 08, this button will
alternately activate and de-acti-
vate the checklist mode on the
MFD.
COURSE SELECT
KNOB/BUTTON
NAV
CHK
LIST
CRS
CRS SEL