BendixKing SG 465 System EFS 50 - Manual (Page 46)

EADI Operation
2.2.1 Issued 4/95 SW 06/07/08/11
This section, EADI Operation, of
the EHI
50 Pilot’s Guide
describes the EADI operational
controls of the CP 467 used with
an ED 551/A EADI.
EADI controls are limited to three
basic functions: EADI display
brightness adjustment, DH (deci-
sion height) set and Radio Alti-
tude test.
For clarification on a particular
display or operational feature
refer to section IV, EADI DIS-
PLAYS or section V, OPERAT-
ING INSTRUCTIONS.
EADI OPERATION
EADI DETAILED OPERATING CONTROLS
Figure 2.2.1
CP 467 EFIS CONTROL PANEL
BRIGHTNESS
The BRT knob controls the dis-
play brightness.
Note: The display brightness
control provides full range dim-
ming to allow night operation
in no- or low-light situations.
The lower limit of the display
brightness may appear as an
inoperative tube during normal
daylight operation. It is there-
fore advisable to check the
BRT knob setting during pre-
flight test.
To ensure maximum display
tube life, it is highly recom-
mended that the display be
operated at the lowest accept-
able brightness level.
DH SET
To set the Decision Height, pull
out and turn the DH knob. Turn-
ing clockwise will increase the
HSI ARC NAV
RNG
1-2
HDG CRS
RNG
RALT TST SYS
BRT
REF
DH
BRT
DH