BendixKing SG 465 System EFS 50 - Manual (Page 57)

MFD Operation
2.4.2 Issued 4/95 SW 06/07/08/11
Those push buttons which have
common operation between the
MFD and EHSI control panels,
CP 467 and CP 468, will function
as defined in the section 2.1,
EHSI Operation unless otherwise
noted in this section. For
detailed operational information
on those buttons please refer
section 2.1.
TCAS ONLY
BUTTON
This button is not functional in
Software 06 or 07. The message
“FUNCTION NOT IMPLEMENT-
ED” will be displayed on the MFD
if this button is pressed with
these software versions.
With software 08, this button will
alternately select between “TCAS
ONLY” and the previously select-
ed display on the MFD, if TCAS
is installed.
HSI BUTTON
Will function identical to, but inde-
pendent of, the one on the CP
467. The MFD HSI button will
allow the additional selection of
an optional plan view on the
MFD.
Refer to section 2.1 EHSI OPER-
ATION for detailed information.
ARC BUTTON
Will function similar to, but inde-
pendent of, the one on the CP
467. The MFD ARC button will
allow the selection of an optional
radar only MFD display. This dis-
play will not contain navigation or
map data. The ARC button will
not function while Plan-View is
displayed. The ARC button will
not function while Plan-View is
displayed.
ENT BUTTON
◗ LNAV MAP
The cursor position information
can be transferred to the LNAV
that is selected as the primary
navigation sensor, by pressing
the ENTER button while the cur-
sor and its coordinates are dis-
played. The coordinates of the
cursor will remain displayed for at
least 10 seconds and will disap-
pear from the display within 15
seconds after the ENTER button
is pressed.
◗ PLAN-VIEW MAP
(available with software 07)
When Plan-View is selected,
pressing the enter button will
place the symbolic aircraft, pre-
sent position, at the center (+) of
the display.
◗ CHECKLIST
(available with software 08)
In the Checklist mode the enter
button will generally function to
check items in the list. The
checklist was designed such that
CONTROL PANEL BUTTON OPERATIONS
TCAS
ONLY
HSI
ARC
ENT