Figure 36. slip port settings -2 – CANOGA PERKINS 9135G SNMP Managed Gigabit Ethernet Switch User Manual
Page 46
EdgeAccess Ethernet Switch
Figure 36. SLIP Port Settings
Verify the following settings:
•
Interface:
modem
•
Init Modem At Startup:
Yes
•
Modem Init String:
ats0 = 1
•
Password Enable:
no
•
SLIP Password:
(only if password setting is enabled)
•
SLIP IP Address:
(specified by the customer)
•
SLIP Subnet Mask:
(specified by the customer)
•
SLIP Port Setup:
9600, N, 8, 1
Notice that the parameters have changed automatically. The 9135G is ready to manage by SLIP
connection.
4.2
Setting up a Serial Line IP (SLIP) Connection with Windows NT
Step 1 Verify that a modem is installed in the computer that will be used for the SLIP session. The
modem, which is normally configured when Windows NT is installed, should be listed under
Modems in the Control Panel screen. Click Start, then Settings, then Control Panel, and double
click the modem icon. See Figure 37.
Model 9135G SNMP Managed Gigabit Ethernet Switch
4-2