CANOGA PERKINS 9135G SNMP Managed Gigabit Ethernet Switch - Manual (Page 57)

EdgeAccess Ethernet Switch
5.2.1 Management Board – Characteristics
In-Band Support: SNMP, TELNET, TFTP, BOOTP
MIBs Supported:
MIB II, Bridge MIB
Private MIB (contains RMON group 1 counters)
Terminal
Port: EIA-232 protocol
DTE
DE-9 female connector
VT100 compatible
SLIP (Modem) Port:
EIA-232 protocol
DCE
DE-9 male connector
Modem control
SLIP protocol
Software Download:
Via TFTP
Network IP Configuration:
Via BOOTP or User Entry
5.4 Alarms
General: Per port relay activated by:
• Unit Power Fail
• Link Loss
• Remote Fault
Relay Per Port:
Three dry contacts (common, normally open, normally closed)
located on the rear panel.
Contact current: 30 VDC Max. , 1A
Screw-terminal strips
Model 9135G SNMP Managed Gigabit Ethernet Switch 5-3