Leica Geosystems TPS1100 Professional Series - Applikation - Feldhandbuch (Teil 2) - Manual (Page 19)

19
Sets of
angles
Enter Point Id at first target point.
If distances are measured: enter Refl. Ht. and check selection of
the Prism Type at the bottom of the display.
F1 F1 F1 F1 F1
ALL
SETS\ First Set
Point Id : 2
Refl. Ht. : 1.700 m
MC
To call the measurement dialog.
F1 F1 F1 F1 F1
MEAS
To measure and record first target point
(See chapter
"Measurement options").
Repeat for each desired target.
You may define different reflector heights and prism types for each
target. The values entered for each target will be recalled when
measuring further sets.
Ends first half of first set: all targets have been measured the first
time.
F5 F5 F5 F5 F5
DONE
Auto Meas.
= YES Option of instruments with ATR.
Fine pointing and measurement to specified
target are fully automatic.