Leica Geosystems TPS1100 Professional Series - Applikation - Feldhandbuch (Teil 2) - Manual (Page 56)

56 Auto Record
Auto Record is especially designed for instruments with ATR.
It is used to automatically record measurement data, based on
following recording modes:
• Time mode,
• Distance mode
and/or
• Stop mode.
You can combine the recording modes and manually record
measurement data at any time in these modes.
Auto Record in Stop mode is recommended for ordinary detail
surveys. As long as the prism is moving Auto Record will not record
any measurement data. When the prism stops for a few seconds
Auto Record will record measurement data, you may then start
toward the next point.
Auto Record in Time or Distance mode is best for large survey,
e.g. for topographic surveys which are not suitable for
photogrammetry.
Introduction