360 Systems Instant Replay DR-552 - Manual (Page 12)

Instant Replay Owner’s Manual page 7
Display Module
THE DISPLAY MODULE
For most operations, the display shows the Index number, Cut Name, and the running time of the
currently selected Cut.
The currently selected Bank number is displayed in the lower right corner, followed by the Hot-
Key Assignment of the current Cut. If the displayed Cut is not assigned to a Hot-Key in the
current Bank, this number will be 00.
When a Cut starts playing, the lower line of the Display changes to show the Name of that Cut,
followed by the running time in Hours:Minutes:Seconds, as shown in the picture above.
Other messages appear on the display during special operations. These are explained in
appropriate sections of this manual.
Hot-Keys
There are four primary uses for Hot-Keys:
•
Triggering playback of assigned Cuts
•
As an alphanumeric keyboard
•
Bank selection, using the top row of keys
•
Drive selection, when an external drive is connected, using the “E” and “I” keys
The main array of 50 buttons are Hot-Keys numbered 1 through 50. A Hot-Key's primary
function is to trigger playback of a Cut assigned to it. Hot-Keys light up whenever their assigned
Cut is playing.
Each button additionally carries an alphabet character. In operations that require the entry of text
and numbers, such as Change Cut Name, Change Bank Name and Move Cut, the Hot-Keys serve
as a typewriter-style keyboard. Key number 50 is a Backspace key that allows deleting characters.
Keys 48 and 49 are cursor movement keys that allow you to move to any character position. Key
number 40 is an A
STERISK (*) character used by the Find function. Keys 41 to 47 all function as a
space bar.
In the Bank Select mode, the numbers 1 through 10 on the top row select the corresponding
Banks numbered 1 through 10. When an external drive is connected and enabled in the
Configuration menu, the I and E keys select the Internal or External drive.