360 Systems Instant Replay DR-552 - Manual (Page 25)

page 20 Instant Replay Owner’s Manual
CHAPTER THREE – Command Summary
To Use The Menus
•
Press M ENU .
•
Use the S CROLL A RROWS to select the desired Menu. Press E NTER to select a
specific Menu item.
•
Use the S CROLL A RROWS to select the desired option for that menu item.
•
To adjust the value of the selected item press E NTER . The second line of the display
will flash.
•
Use the S CROLL A RROWS to set the value. (Where required, enter it using the
keyboard keys).
•
Press E NTER to confirm your selection or C ANCEL to restore the previous
programmed value.
NOTE: At any time, C ANCEL will move operation back one level (from Value Entry to
Option Selection to Menu Selection to Normal Operation). Also, pressing M ENU again
(turning it off) will return to normal operation. Refer to the Menu Map below for the
location of the various options within the Menu tree.
To Record A Cut
•
Set THRESHOLD and turn off RECORD/ERASE LOCKOUT (Record Setup Menu).
•
Set AUDIO INPUT to ANALOG or DIGITAL (in Configuration Menu).
•
Press R ECORD button. Set Input Level controls (for Analog Input only).
•
Select an alternate Index Number if desired using S CROLL A RROWS .
•
Press P LAY ; machine will enter Record mode.
•
When done, press S TOP .
•
Enter Cut Title using alphanumeric keys.
•
Press E NTER to save title.
T
T T I
I I P
P P :
: :
If you wish to place a Cut in an Index Number that is far from the one supplied by
default, just use the number supplied. After recording, use the Move operation to reassign
it to the desired Index Number. Move allows direct entry of an Index number using
numeric keys.
To Erase A Cut
•
Select the Cut.
•
Press the M ENU button.
•
Select OPERATIONS.
•
Press E NTER .
•
Select ERASE.
•
Press E NTER .
•
Press E NTER again to confirm.
•
To erase additional Cuts, select another Cut using the C URSOR A RROW keys (H OT -
K EY s 48 and 49) and press E NTER twice.
•
When done, press M ENU to exit.
•
Note that RECORD/ERASE LOCKOUT (in RECORD SETUP Menu) must be OFF.
To Assign A Cut To A Hot-Key
•
Press the A SSIGN H OT -K EY button.
•
Select the desired Cut using S CROLL A RROWS or F IND .