360 Systems Instant Replay DR-552 - Manual (Page 18)

Instant Replay Owner’s Manual page 13
Editing the Playlist
Note that if PLAYLIST PROTECTION is ON, the Playlist cannot be edited. See page 22.
To remove a Cut from the Playlist:
•
Use the S CROLL A RROWS to find the Cut you want to delete.
•
Press C ANCEL to remove it from the list.
•
Press Enter to confirm the operation.
To insert a new Cut into the Playlist:
•
S CROLL to the position you desire within the list.
•
Press the H OT -K EY that corresponds to the Cut you want to insert. It will be inserted
immediately after the position you selected, and the Playlist will increment to display
the new Cut.
To append a Cut to the end of the Playlist:
•
S CROLL U P through the list until you see END OF PLAYLIST.
•
Press the appropriate H OT -K EYS to add additional Cuts to the list.
Changing the Playlist Playback Order “On-the-Fly”
The S CROLL A RROWS and E NTER key can be used in real time to change the sequence in which
the Cuts are played. At any time you can S CROLL through the list. If you then press E NTER , the
step you selected will be played next, and the Playlist will continue from that point onward. You
can S
CROLL U P the list, effectively skipping steps in the Playlist, or you can S CROLL D OWN to
repeat steps. This can be done while stopped or during playback.
When a Cut is playing (and Playlist is not enabled), pressing the P LAYLIST key enables the
Playlist mode and "cues up" the first Cut of the Playlist. The current Cut will play to completion
and the button corresponding to the first Cut in the Playlist will flash. However, the Playlist will
not execute until you press P
LAY , even if it is a Follow-On Playlist.
When executing a Playlist, the bottom line of the display shows the Cut currently playing. The
top line shows the Cut that is selected. Once you have S
CROLL ed to another step, it will be
displayed until playback stops. If you have not pressed E NTER , the programmed next to play Cut
will be selected. This is important during Manual Step Playback as you will have to reselect the
next step if the playing cut ends.
Clearing the Playlist
To clear the Playlist in the currently selected Bank:
•
Hold down the C ANCEL button, then press P LAYLIST .
•
The display shows the message
CLEAR PLAYLIST?
PRESS ENTER/CANCEL
•
Press E NTER to confirm that you wish to clear the Playlist.
There is also a CLEAR PLAYLIST entry in the Playlist Menu that performs the same function.
Clearing the Playlist does not change the programmed Playlist Type for that Bank. Note that if
PLAYLIST PROTECTION is ON, the Playlist cannot be cleared. See page 22.
METERING AND LEVEL CONTROLS
Level Meters