360 Systems Instant Replay DR-552 - Manual (Page 44)

Instant Replay Owner’s Manual page 39
Some possible error messages are:
COULD NOT OPEN FILE ........ FILE TO SEND COULD NOT BE OPENED
DISK ERROR........................... ERROR READING FILE TO SEND
FILE IS EMPTY ....................... FILE TO SEND IS EMPTY
NO FILES TO SEND ............... DRIVE TO SEND IS EMPTY
PART OF FILE MISSING ........ FILE IS SHORTER THAN EXPECTED
TOO MANY ERRORS .............. 20 DISK OR FILE ERRORS OCCURRED
After the brief error message the display then changes to:
TRANSFER INCOMPLETE
PRESS ENTER/CANCEL
After pressing E NTER or C ANCEL the display shows briefly:
FILES SENT: 0
ß
NUMBER OF FILES TRANSFERRED WITHOUT ERRORS
PLEASE WAIT
If any files could not be sent the display shows:
FILES SENT: 0
ß
NUMBER OF FILES TRANSFERRED WITHOUT ERRORS
FILES NOT SENT: 1
ß
NUMBER OF FILES NOT SENT DUE TO ERRORS
Note that Errors shown in the Transmitter are never the result of cabling or interface problems;
they reflect a problem within the unit. Transmitter errors will also be shown on the Receiver, but
Receiver errors are shown on the Receiver only.
File Transfer (RECEIVER)
When Instant Replay is idle and FILE RECEIVE is ON, it monitors the selected RECEIVER
INPUT (XLR-3 or RCA) for a file transfer with destination name that matches the stored receiver
name. When a file transfer addressed to the Receiver begins, the display shows the following:
FILE 1 OF XX
ß
FILE NUMBER AND TOTAL NUMBER OF FILES
00% COMPLETED
ß
PERCENT COMPLETION FOR THE CURRENT FILE
•
If C ANCEL or S TOP is pressed, the transfer proceeds while the following prompt is
displayed:
QUIT TRANSFER?
PRESS ENTER/CANCEL
•
Press C ANCEL for the transfer to proceed.
OR
•
Press E NTER to exit from the transfer. The display will show:
TRANSFER INCOMPLETE
PRESS ENTER/CANCEL
When a transfer is completed without errors, the following message appears:
TRANSFER COMPLETE
NO ERRORS
If a multi-file transfer was performed, the display then shows:
GOOD FILES: XX
ß
FILES RECEIVED WITHOUT ERRORS