Cub Cadet 2000 Series - Manual (Page 176)

2000 Series Tractors
170
7. Disconnect the deck lift actuator:
7a. Remove the inboard E-ring from the pin that
connects the lift actuator to the lift shaft con-
necting arm.
7b. Remove the pin by sliding it out to the left.
8. Remove the split spacers. See Figure 8.29.
9. Slide the split bushings out of the notches in the
frame
10. Remove the split bushings from the lift shaft.
NOTE: The washers were installed onto the lift shaft
before the bell cranks were welded in place
and can not be removed or replaced.
11. Remove the two screws that hold the lift shaft
retaining bracket, on each side of the frame, using a
3/8” wrench. See Figure 8.32.
Figure 8.40
Inboard E-ring
Figure 8.41
Split spacer
Figure 8.42
Lift shaft
retaining bracket