Cub Cadet 2000 Series - Manual (Page 28)

2000 Series Tractors
22
8. Slide the brake pedal shaft to the left enough for it to
clear the frame on the right side.
9. Lower the shaft enough to gain access to the cotter
pin that secures the brake rod to the pedal shaft.
10. Remove and discard the cotter pin.
See Figure 3.13.
11. Remove the pedal shaft from the tractor.
12. Install the brake pedal shaft by following the previ-
ous steps in reverse order.
NOTE: The cotter pin that secures the brake rod to
the pedal shaft can be replaced with a bow
tie clip (714-04040). This will make it easier
to perform the brake rod adjustment.
13. Perform a brake rod adjustment by following the
procedures described in the brake rod adjustment section of this chapter.
14. Test drive the tractor in a safe area before returning it to service.
Figure 3.13
Cotter pin