Cub Cadet 2000 Series - Manual (Page 68)

2000 Series Tractors
62
20. Place a 3/16” bead of Loctite ® Ultra Black or similar
sealant around the perimeter of the right housing
mating face. See Figure 5.58.
21. Slide the left transmission housing over the left axle
assembly and set it into position, aligning the
mounting holes with the threads.
22. Apply a small amount of releasable thread locking
compound such as Loctite® 242 (blue) to the four-
teen hex cap screws that hold the two transmission
halves together.
23. Install the fourteen hex cap screws and tighten them
to a torque of 150 - 210 in lbs (17 - 24 Nm).
NOTE: Torque all the hex cap screws securing the
transmission housings together in a cross
pattern.
24. Slide the hub assemblies onto the axle shafts.
25. Apply a small amount of releasable thread locking
compound such as Loctite® 242 (blue) to the wheel
hub patch bolts.
26. Install the hub patch bolts and washer. Tighten
them to a torque of 260 - 350 in lbs (29 - 40 Nm).
27. Install the output shaft double lip seal using a seal
pusher and hammer. See Figure 5.60.
28. Apply anti-seize to the actuator pin contact surface
of the brake actuation arm.
29. Reassemble the brake assembly as follows: yoke,
actuation arm, torsion spring, flat washer, anti-rota-
tion plate, lock nut, hex cap screws, actuation pins,
puck plate and brake pad.
30. Secure the brake assembly together using tape.
31. Insert the brake pad into the right transmission
housing.
32. Slide the brake disk over the output shaft.
NOTE: The center shoulder of the brake disk faces
outward.
Figure 5.58
3/16” bead of sealant
Figure 5.59
Patch bolt
Figure 5.60
Output shaft seal