Cub Cadet 2000 Series - Manual (Page 40)

2000 Series Tractors
34
12. Gently pry up the rubber foot pad on one side of the
tractor enough to gain access to the screw under it.
See Figure 4.23.
13. Remove the screw using a 1/2” wrench.
14. Repeat steps 10 & 11 on the other side of the trac-
tor.
15. Remove running board brackets by removing the
two screws, indicated by the arrows in Figure 4.24,
that hold each of them to the frame using a 1/2”
wrench.
16. Lift the rear of the fender far enough for it to clear
the fuel tank and slide the fender off of the tractor.
NOTE: If the running board and fender need to be
separated:
• Remove the six nuts and bolts, indicated by the
arrows in Figure 4.25, that hold the fender to
the running board using a pair of 7/16”
wrenches.
17. Install the fender and running board by following the
previous steps in reverse order.
NOTE: The seat switch connector on the
GTX2154LE must be wire tied back together
and attached to the seat frame. Failure to do
this can cause the connector to get caught in
the seat bracket and rip the wires out of the
seat. If this happens, the tractor will shut
down when the brake is released and the
whole seat must be replaced.
Figure 4.23
Screw
Rubber foot pad
Figure 4.24
Figure 4.25